Introduction
The pH meter is mainly designed for Arduino controllers and has a convenient and sensible “Gravity” connector and a group of functions. instantaneous connection on your probe and your Arduino to get pH measurements at ± 0.1pH (25 ℃). For the maximum hobbyist, this awesome accuracy range and it is low value make this a wonderful device for biorobotics and other projects! It has an LED which goes because of the electricity Indicator, a BNC connector, and a PH2.0 sensor interface. to use it, just join the pH sensor with the BND connector, and plug the PH2.zero interface into the analog input port of any Arduino controller.
![](https://www.circuitdatasheet.com/wp-content/uploads/2023/10/IMG-20231028-WA0008.jpg)
Features of PH Sensor Gravity Module
- pH Sensor with BNC Connector
- pH2.0 Interface (3-foot patch )
- Gain Adjustment Potentiometer
- Power Indicator LED
Pinout of PH Sensor Gravity Module
Pin Number | Pin Type | Description |
1 | VCC | Supply Voltage |
2 | GND | Ground Pin |
3 | SCL | Serial clk input |
4 | SDA | Serial Data Pin |
Specifications of PH Sensor Gravity
Module Power | 5.00V |
Response Time | ≤ 1min |
Accuracy | ± 0.1pH (25 ℃) |
Measuring Temperature | 0 – 60 ℃ |
Measuring Range | 0 – 14PH |
Module Size | 43 x 32mm(1.69×1.26″) |
Datasheet of PH Sensor Gravity Module
Download ( PH Sensor Gravity Module) Datasheet from the link given below.